1The EEnndduurraannccee 440000is a electricpowered glider that can perform like a true sail plane. With itsaileron controls and at “V” tail, this gli
10FLYING THE ENDURANCE 400CHECK YOUR EQUIPMENTPrior to going to the flying field, with radio batteries fullycharged, turn on both receiver (Rx) and tr
2USING THIS INSTRUCTION MANUALBefore you begin assembling your EEnndduurraannccee 440000ARF,take some time to read through this entire instruction b
3Caution:Before starting, carefully go over all highstress areas with an epoxy or wood glue toconfirm all areas are well glued. Warnings about Lithium
4WingInstalling Ailerons1. Collect the following parts:(2) Wing ( Left & Right)(2) Ailerons ( Left & Right)(8) Mini CA hinges(2) Wood contro
53. Tape the hex nut to the bottom of the wing.4. Plug one 6" extension wire into the servo. Tape the servo wire to the extensions.IMPORTA
69. Using rubbing alcohol, clean the bottom of theservo where the double sided tape will beapplied. Making sure that the both the wing and theser
73. Spread epoxy on both the inside “V” of thestab and the stab platform of the fuse. Replace the stab on the “V” platform and,check that the stab
88. Lay the pushrod on the table top just like it sitsinside the fuselage. Bend the pushrod 90 degrees at the mark youjust made. Bend the wire so t
9CG Location and Control ThrowsThe EEnndduurraannccee 440000balance point is 2-1/4 to 2-1/2” back from theleading edge of the wing next to the fusela
Comments to this Manuals