1INSTRUCTIONSWARNINGA radio-controlled model is not a toy and is not intended for persons under 16 years old. Keepthis kit out of the reach of younge
106. Repeat for the other three horns.7. Locate the four 2-56 x 6” pushrods and installthe nylon snap link on the end. Thread the rodinto the snap
112. Install the cover door. Clear tape will hold it inplace and be easy to remove if needed.3. * You will need a double sided heavy duty servooutp
12Elevator Servo Installation1. Install the elevator control horn on the inboardedge of the elevator on the right side of thefuselage. Align so the
13Throttle Servo Installation1. Two cutout are provided for the throttle servo,one on each side of the fuselage. Mount yourservo on the side that ma
143. Insert the cap in the tank, making sure thevent line is at the top of the tank. The top ofthe tank is the one closes to the cap. Theclunk shoul
154. The battery can be wrapped in form and fittedinto the opening.Final Assembly1. Locate the 1/4-20 nylon bolt and the wing boltreinforcement pl
2Congratulations on your purchase of the HotStik ARF. Every effort has been made to pro-duce a lightweight, straight, easy to assembleaircraft. Becaus
3ADHESIVES & GLUING TECHNIQUESCA adhesives are specially formulated to firmly glue theplywood, hardwood, and balsa used in your model and towithst
2. Bolt the landing gear in place using the two 6-32 bolts and flat washers. Be sure to use lock-tite on the bolts. The blind nuts are pre-installed
54. Find the center of the stab at the trailing edgeand make a mark at the location. Place thestab on the fuselage and align the center markat the
69. Mix some 5-minute epoxy and force into theholes for the joiner wire in the elevators. Fitthe joiner wire into the holes and cover withmasking ta
715. Remove the covering between the lines youmarked on the top of the stab where the finmounts. 16. Remove the covering on the post of the fin,le
820. Locate the rudder and install the hinges usingpins in the holes to make sure the hinges gohalf way into the rudder.21. Mix some epoxy and for
95. Drill a 3/16” hole in line with the throttle arm onyour engine.4. Reinstall the engine and bolt in place usingthe 6-32 bolts and aircraft lock
Comments to this Manuals